Português PT
English
Valken "The Unit" Paintball Fill Station
- Write a review
€599.95
Tax included
Paintball compressed air fill stations were once expensive, high-maintenance pieces of equipment but those days are over with the introduction of THE UNIT Fill station for paintball! Simple to operate for almost any customer and just as easy to keep clean and maintained for reliable operation, THE UNIT makes filling a paintball air system easy and safe. Constructed from solid billet aluminum with CNC machined air passages and operated with a simple lever, THE UNIT has no moving o-rings, filtered exhaust, side and front air outlets and can be completely rebuilt in seconds! For consistent, reliable and user-friendly paintball compressed air system fills, THE UNIT is unbeatable.
Pressure cylinder sizes: 0.8l; 1.1l; 1.5l; 1.9l
Filling pressures: 200 bar / 300 bar
Filling panels for table top assembly with closed plastic panel housing
Can be attached using four bores on the base
Direct valve actuation
Automatic bleed
Adjustable valve play
Max. and min. valve stop setting
Rust-free valves with several hundred thousand switching cycles
Pressure input at the back
Possibility of distributing pressure to several filling panels though a T piece
Connection of the filling hose at the back of the device- Space in front of the panel remains clear.
04140401
Click on a thumbnail to load the video
16 other products in the same category:
Easy operation.
Pushbutton vent.
Can Be used with Scuba Tanks with A Clamp / Yoke connector
Rated for 300bar/4500psi
The Manta Dual Fill Panel is designed for charging high-pressure cylinders (200/300 BAR), has reliable lever valves with automatic vent, made of very high quality materials. It is possible to charge two cylinders simultaneously. At the end of the hose there is a quick-connect coupling with a fuse and a convenient handle. On both sides fit two typical HP 5/8′ inputs, allowing several panels to be connected in series. The Fill Panel has large, easy-to-read pressure gauges and a solid steel housing with an anti-corrosion coating. The recommended way to mount the device: fastening to the table or hanging on the wall.
A tool that is used during the service of a Manta Quick Filler. The tool is specially designed for easy access to the quick fillers internals if you want to replace any part inside.
Complete Oring Kit for Quick Disconnects on Remotes
The Manta Fill Panel is designed for charging high-pressure cylinders (200/300 BAR), has reliable lever valves with automatic vent, made of very high quality materials. At the end of the hose there is a quick-connect coupling with a fuse and a convenient handle. On both sides fit two typical HP 5/8′ inputs, allowing several panels to be connected in series. The Fill Panel has large, easy-to-read pressure gauges and a solid steel housing with an anti-corrosion coating. The recommended way to mount the device: fastening to the table or hanging on the wall.
The Steel Braided Hose allows users to connect a fill panel with a compressor or another fill panel. Our hoses have got male connections at each end.
If you want to connect two hoses with each other you may require the Air Line Connector. This adaptor has two female hand-tight connections on the both sides.