Totem Air Regulator Part S9 Fill Nipple

Totem Air Regulator Part S10 - 5K Burst Disk

Used on 3000 PSI preset regulators

Parts to repair Totem Air Preset Regulators.

Totem Air Regulator Part S4 - 1.8K Burst Disk

Used on preset regulators with 3000 and 4500 PSI

Parts to repair Totem Air Preset Regulators.

Preset with excellent quality at low prices.

Screws in any Standard 4500psi Tank, Plated aluminum piston that produces an industry leading recharge rate and virtually eliminates reg shoot down, Non wrist digging, low profile design fill valve, All black tactical look, Meets all DOT, CGA and ASTM specifications, 4500psi

Parts to repair Totem Air Preset Regulators.

Used CO2 Pin and On/Off Valves

Preset with excellent quality for 3000 PSI bottles.

Parts to repair Totem Air Preset Regulators.

Parts to repair Totem Air Preset Regulators.

The latest Totem Air creation, the "Totem Air Regulator Pro Swivel," is excellent and surprisingly reasonably priced.

The regulator's output pressure is adjustable from 500 to 800 psi.  The preset outlet pressure can be modified by omitting washers. A regulator with one disk left in it will provide an output of roughly 450 to 500 psi. You will have 800 psi if you leave the regulator in its current state.

Additionally, the filling nipple's position can be flexibly adjusted. You can turn it on the adjustment wheel to your desired position after loosening three screw bolts. This will prevent the fill nipple to be positioned under the marker or in another undesireble position.

Parts to repair Totem Air Preset Regulators.

Centerflag inline regulator made with good quality materials with output control from 0-450 psi, using an allen adjustment wrench from below.

You can install a pressure gauge, so you can always check the inlet pressure for the marker.

Parts to repair Totem Air Preset Regulators.

This is a high quality micro gauge to display your current pressure from your regulator. Great upgrade or addition to your paintball marker!