Manta Steel Braided Hose 10 mt
Reference: 04140310
Maximum working pressure 35MPa
Power supply typical HP 5/8” 300Bar socket
Cable length 1m, 2m, 5m, 10m, 20m
The Steel Braided Hose allows users to connect a fill panel with a compressor or another fill panel. Our hoses have got male connections at each end.
in the same category
16 other products in the same category:
4 stars -based on 250 reviews
4 stars -based on 250 reviews
This is a high quality micro gauge to display your current pressure from your regulator. Great upgrade or addition to your paintball marker!
4 stars -based on 250 reviews
Preset with excellent quality at low prices.
4 stars -based on 250 reviews
1.5 Liter Tank (4500 PSI / 300 bar)
PI certification
Weight 1000g
Diameter 110 mm
Height 248 mm
Regulator with HP 800 psi or LP 450 psi Output
4 stars -based on 250 reviews
Keep Your Co2 bottle clean and protected with a tank cover
4 stars -based on 250 reviews
The Steel Braided Hose allows users to connect a fill panel with a compressor or another fill panel. Our hoses have got male connections at each end.
4 stars -based on 250 reviews
4 stars -based on 250 reviews
4 stars -based on 250 reviews
0.8 Liter Tank (4500 PSI / 300 bar)
PI certification
Weight 650g
Diameter 111 mm
Length 155 mm Regulator with HP 800 psi or LP 450 psi Output
4 stars -based on 250 reviews
0.8 Liter (4500 PSI / 300 bar)
PI certification
Weight 650g
Diameter 111 mm
Length 155 mm
4 stars -based on 250 reviews
This is a high quality micro gauge to display your current pressure from your regulator. Great upgrade or addition to your paintball marker!
4 stars -based on 250 reviews
Great for paintball scenario, tactical or recreational. Flexivel which allows you to maneuver through even the most difficult terrain. It is very durable and works with all cylinders of compressed air and Co2
4 stars -based on 250 reviews
This transfiller comes with a flexible hose to make filling much easier.
4 stars -based on 250 reviews
Centerflag inline regulator made with good quality materials with output control from 0-450 psi, using an allen adjustment wrench from below.
You can install a pressure gauge, so you can always check the inlet pressure for the marker.
4 stars -based on 250 reviews
The Hardline "Armored" Padded Tank Cover is designed to protect your air system from dents, scratches and other wear-and-tear. Surrounded with impact-resistant neoprene, the Hardline Padded Tank Cover helps keep your tank exterior looking good as new. Regulator and tank not included.
4 stars -based on 250 reviews
Easy operation. Pushbutton vent. Can Be used with Scuba Tanks with A Clamp / Yoke connector Rated for 300bar/4500psi
Product added to compare.